Mohlo by se vám také líbit

Informovat o naskladnění knihy

Více informací o knize Drone Autopilot Programming for Beginners

• Parametry knihy
• Anotace
• Oblíbené z jiného soudku

Nákupem získáte 40 bodů

Anotace knihy

Turn your drone from something you fly into a system you can understand, monitor, and control with software.

Programming an autonomous aircraft is not simply a matter of sending commands. Your application must understand whether the vehicle is connected, whether it is ready to move, what operating state it is in, whether positioning information is reliable, whether a request was accepted, and what should happen when something goes wrong.

Drone Autopilot Programming for Beginners provides a structured introduction to this complete development process.

Starting with the architecture of a programmable aircraft, you will learn how the flight controller, autopilot software, communication layer, ground station, companion computer, and application code work together. The book then progressively moves from understanding the system to simulation, vehicle monitoring, programmatic actions, waypoint applications, dynamic movement, failure handling, and responsible hardware deployment.

You will learn how to:

• Understand how a programmable aircraft is organized
• Separate high level application logic from time critical stabilization
• Understand the responsibilities of an autopilot
• Work with vehicle states and operating behavior
• Understand arming, disarming, home position, Return, Hold, Land, and Offboard operation
• Configure and inspect a vehicle using a ground control station
• Prepare a reproducible software workspace
• Work safely with Software In The Loop testing and Gazebo
• Understand communication packets, messages, heartbeats, acknowledgements, routing, and signing
• Connect an application to a simulated vehicle
• Work with asynchronous data streams

The book uses a cumulative development path:

architecture → PX4 → safety → tools → simulation → MAVLink → Python → telemetry → control → navigation → missions → Offboard → reliability → hardware.

A central principle throughout the manuscript is that sending a request is not the same as proving that the aircraft reached the intended state. For example, the practical first flight application checks readiness before arming, observes altitude after requesting takeoff, enters Hold, lands normally, and confirms that the aircraft is no longer airborne.

The final waypoint application brings the earlier lessons together. It connects to the aircraft, validates vehicle and positioning readiness, uploads the route, arms the aircraft, begins autonomous operation, monitors progress and vehicle information, reacts to failures, and provides a controlled path toward physical deployment.

The book also gives safety and reliability appropriate attention. Readers learn to move gradually from SITL to actuator checks without propellers, controlled manual operation, simple automated takeoff and landing, short waypoint testing, log review, and only then more complex operation.

This book is written for beginners and early intermediate developers, including software developers entering autonomous systems, engineering and robotics students, researchers, companion computer experimenters, and drone users who want to understand the software behind the aircraft.

If you want to move beyond operating drones and begin designing software that can observe vehicle state, make controlled requests, verify results, recover from failures, and support reliable autonomous operation, this book provides the foundation.

Parametry knihy

• Plný název: Drone Autopilot Programming for Beginners
• Podnázev: Learn PX4, MAVLink, Python, Flight Modes, GPS Navigation, Telemetry, and Autonomous Mission Development
• Autor: Thom Haagenrud
• Jazyk: Angličtina
• Vazba: Brožovaná
• Počet stran: 220
• EAN: 9798193804598
• ID: 53567390
• Nakladatelství: Independently published
• Hmotnost: 274 g
• Rozměry: 229 × 152 × 14 mm
• Datum vydání: 20. August 2026

---

---

---